Filter
Top Products
As you exercise, the workout intensity level bar will
indicate the approximate intensity level of your ex-
e
rcise. For example, if eight of the indicators in the
bar are lit, the bar shows that your intensity level is
i
deal for aerobic exercise.
To reset the console, press the Stop button, re-
move the key, and then reinsert the key.
7. Measure your heart rate if desired.
Note: If you use the handgrip pulse sensor and
the chest pulse sensor at the same time, the
console will not display your heart rate accu-
rately.
For more information on the chest pulse
sensor, see page 10.
Before using
the handgrip
pulse sensor,
remove the
sheets of clear
plastic from
the metal con-
tacts. In addi-
tion, make
sure that your
hands are clean.
To measure your heart rate,
stand on the foot
rails. Hold the contacts for approximately ten
s
econds—avoid moving your hands.
When your
pulse is detected, your heart rate will be shown.
F
or the most accurate heart rate reading, con-
tinue to hold the contacts for about 15 sec-
onds.
8. Turn on the fan if desired.
The fan has high and low speed settings. Press the
Fan button repeatedly to select a fan speed or to
turn off the fan. Note: If the fan is on when the
walking belt stops, the fan will automatically turn off
after a few minutes.
9. When you are finished exercising, remove the
key from the console.
Step onto the foot rails, press the Stop button, and
adjust the incline of the treadmill to the lowest
setting. The incline must be at the lowest setting
when you fold the treadmill to the storage posi-
tion, or you may damage the treadmill. Next, re-
move the key from the console and put it in a secure
place.
When you are finished using the treadmill, switch
the reset/off circuit breaker to the “off” position and
unplug the power cord. IMPORTANT: If you do
not do this, the treadmill’s electrical compo-
nents may wear prematurely.
ETVM81507
(SFTL81507)
Workout Intensity Level Bar
Contacts
16