Filter
Top Products
15
H
OW TO TURN ON THE POWER
IMPORTANT: If the treadmill has been exposed to
c
old temperatures, allow it to warm to room tem-
perature before turning on the power. If you do not
d
o this, the console displays or other electrical
components may become damaged.
Plug in the power cord (see
page 13). Next, locate the
reset/off circuit breaker on
the treadmill frame near the
power cord. Switch the cir-
cuit breaker to the reset po-
sition.
IMPORTANT: The console features a display demo
mode, designed to be used if the treadmill is dis-
played in a store. If the displays light as soon as
you plug in the power cord and switch the circuit
breaker to the reset position, the demo mode is
turned on. To turn off the demo mode, hold down
the Stop button for a few seconds. If the displays
remain lit, see THE INFORMATION MODE on page
23 to turn off the demo mode.
Next, stand on the foot
rails of the treadmill.
Find the clip attached to
the key (see the drawing
to the right) and slide
the clip onto the waist-
band of your clothes.
Then, insert the key into
the console. After a moment, the displays will light. IM-
PORTANT: In an emergency situation, the key can
be pulled from the console, causing the walking
belt to slow to a stop. Test the clip by carefully tak-
ing a few steps backward; if the key is not pulled
from the console, adjust the position of the clip.
Note: If there is a sheet of clear plastic on the face
of
the console, remove the plastic. To prevent dam-
age to the walking platform, wear clean athletic
shoes while using the treadmill. The first time you
use the treadmill, observe the alignment of the
walking belt, and center the walking belt if neces-
sary (see page 27).
N
ote: The console can display speed and distance in
either miles or kilometers. To find out which unit of
measurement is selected or to change the unit of mea-
surement, see THE INFORMATION MODE on page
23. For simplicity, all instructions in this section refer to
miles.
H
OW TO USE THE MANUAL MODE
I
nsert the key into the console.
S
ee HOW TO TURN ON THE POWER to the left.
Select the manual mode.
Each time the key is inserted, the manual mode
will be selected. If you have selected a program,
press any of the program buttons (Event Training,
Aerobic Fitness, Performance, Custom, Heart
Rate Control, or Weight Loss) repeatedly until a
track and the word “Manual” appears on the
screen.
Start the walking belt and adjust the speed.
To start the walking belt, press the Start button,
the Speed increase button, or one of the num-
bered speed (MPH) buttons.
If the Start button or the Speed increase button is
pressed, the walking belt will begin to move at 1
mph. As you exercise, change the speed of the
walking belt as desired by pressing the Speed in-
crease and decrease buttons. Each time a button
is pressed, the speed setting will change by 0.1
mph; if you keep your finger on the button, the
speed setting will change in increments of 0.5
mph. If one of the numbered speed (MPH) buttons
is pressed, the walking belt will gradually increase
in speed until it reaches the selected speed set-
ting.
To stop the walking belt, press the Stop button. To
restart the walking belt, press the Start button, the
Speed increase button, or one of the numbered
speed (MPH) buttons.
Change the incline of the treadmill as desired.
To change the incline of the treadmill, press the
Incline increase and decrease buttons or one of
the numbered incline (% GRADE) buttons.
Each time the Incline increase or decrease button
is pressed, the incline will change by 0.5%. If one
of the numbered incline (% GRADE) buttons is
pressed, the incline will gradually increase until it
reaches the selected incline setting.
4
3
2
1
Reset
Position
Key
Clip