Filter
Top Products
6
5. Identify the Left Pedal (10), which has a notch near
t
he right side. Place the Left Pedal on the Left Pedal
Leg (4). Next, apply a generous amount of grease to
the long side of an M8 x 79mm Bolt Set (65) and the
faces of the two indicated Upper Body Arm Bushings
(
12). Have a second person hold the lower end of the
left Upper Body Arm (29) inside of the bracket on the
Left Pedal Leg. Attach the Left Pedal and the left Upper
Body Arm to the Left Pedal Leg with the Bolt Set.
Attach the other end of the Left Pedal (10) to the Left
Pedal Leg (4) with two M8 x 56mm Button Screws (83)
and two M8 Split Washers (85).
Repeat this step on the right side of the elliptical exer-
ciser.
See step 2. Tighten the two M10 x 108mm Button
Screws (70).
4
1
0
83
65
5
6
5
Notch
2
9
6.
The Console (17) requires four “D” batteries (not
included); alkaline batteries are recommended.
Remove the battery cover from the bottom of the
Console. Insert four batteries into the battery compart-
ment;
make sure that the batteries are oriented as
shown by the diagram inside the battery compart-
ment. Reattach the battery cover.
8. Make sure that all parts of the elliptical exerciser are properly tightened. Cover the floor beneath the
elliptical exerciser to protect the floor from damage. Note: Some extra hardware may be left over.
6
17
Batteries
Battery
Cover
12
Face
G
rease
7. Have another person hold the Console (17) near the
Upright (2). Connect the Upper Wire Harness (30) to
the wire harness on the Console. Connect the Pulse
Wire (20) to the pulse wire on the Console.
Carefully insert all excess wiring down into the Upright
(2). Attach the Console (17) to the Upright with four M4
x 16mm Round Head Screws (69). (Note: The Screws
may be found in the console box.)
Be careful to avoid
pinching the wires.
17
2
69
69
30
Do not pinch
the wires
during this step.
7
20
85