NordicTrack NTL07707.0 Treadmill User Manual


 
16
6. Measure your heart rate if desired.
B
efore using the
handgrip pulse
s
ensor, remove
the clear plastic
film from the
metal contacts.
In addition,
make sure that
your hands are
clean.
To measure your heart rate,
stand on the foot
rails
and hold the metal contacts—avoid moving
your hands. When your pulse is detected, your
heart rate will be shown. For the most accurate
heart rate reading, continue to hold the contacts
for about 15 seconds.
7. Turn on the fan if desired.
T
he fan features high, low, and auto speed set-
tings. Press the Fan button repeatedly to select a
f
an speed or to turn off the fan. When the auto
mode is selected, the speed of the fan will auto-
matically increase and decrease as the speed of
the walking belt increases and decreases. Note: If
the fan is on when the walking belt is stopped, the
fan will turn off automatically after a few minutes.
8.
When you are finished exercising, remove the
key from the console.
Step onto the foot rails, press the Stop button, and
adjust the incline of the treadmill to the lowest
setting. The incline must be at the lowest setting
or you may damage the treadmill when you fold
it to the storage position. Next, remove the key
from the console and put it in a secure place.
When you are finished using the treadmill, switch
the reset/off circuit breaker to the “off” position and
unplug the power cord.
IMPORTANT: If you do
not do this, the treadmill’s electrical compo-
nents may wear prematurely.
C
ontacts