Filter
Top Products
16
Measure your heart rate if desired.
See step 6 on page 13.
Turn on the fan if desired.
S
ee step 7 on page 14.
When you are finished exercising, remove the
key from the console.
When the program has ended, make sure that
the incline of the treadmill is at the lowest set-
ting.
Next, remove the key from the console and
put it in a safe place. Note: If the display remains
lit after the key is removed, the console is in
the “demo” mode. See page 23 and turn off the
demo mode.
When you are finished using the treadmill
, switch
the reset/off circuit breaker to the off position and
unplug the power cord.
HOW TO CREATE A CUSTOM PROGRAM
Insert the key into the console.
See HOW TO TURN ON THE POWER on page
12.
Select one of the custom programs.
To select a
custom pro-
gram, press
the My
Design but-
ton once or
twice. The
words “My
Design” and
the number “1” or “2” will appear in the display.
Note: If the custom program has not yet been
defined, only three columns of indicators will
appear in the matrix in the center of the dis-
play. If more than three columns of indicators
appear, see HOW TO USE A CUSTOM PRO-
GRAM on page 17.
Press the Start button or the Speed increase
button and program the desired speed and in-
cline settings.
A moment after the button is pressed, the walking
belt will begin to move. Hold the handrails and
b
egin walking.
R
efer to the
matrix. Each
custom pro-
gram is di-
vided into
one-minute
segments.
One speed setting and one incline setting can be
programmed for each segment. The speed setting
for the first segment will be shown in the flashing
Current Segment column of the matrix. (The in-
cline settings are not shown in the matrix.) To pro-
gram a speed setting and an incline setting for the
first segment, simply adjust the speed and incline
of the treadmill as desired by pressing the Speed
and Incline buttons. Every few times a Speed but-
ton is pressed, an additional indicator will appear
or disappear in the Current Segment column.
When the first segment of the program ends, a se-
ries of tones will sound and the current speed set-
ting and the current incline setting will be saved in
memory.
The three columns of indicators will then
move one column to the left,
and the speed set-
ting for the second segment will be shown in the
flashing Current Segment column. Program a
speed setting and an incline setting for the second
segment as described above.
Continue programming speed and incline settings
for as many segments as desired; custom pro-
grams can have up to forty segments. When you
are finished with your workout, press the Stop but-
ton twice. The speed and incline settings that you
have programmed and the number of segments
that you have programmed will then be saved in
memory.
When you are finished exercising, remove the
key from the console.
See step 7 at the left.
4
3
2
1
7
6
5
Current Segment