Filter
Top Products
10
12. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical exerciser.
11. The Console (11) can be operated with four
1.5V “D” batteries (not included); alkaline batter-
i
es are recommended. I
MPORTANT: If the
ellipical exerciser has been exposed to cold
t
emperatures, allow it to warm to room tem-
perature before inserting batteries into the
Console. If you do not do this, the console
displays or other electronic components
may become damaged.
Locate the two battery
covers on the back of the Console. Press the
tabs on the battery covers, and remove the bat-
tery covers. Next, insert two batteries into each
battery compartment;
make sure that the bat-
teries are oriented as shown by the symbols
inside the battery compartments.
Then, reat-
tach the battery covers.
The Console (11) can also be operated with a
regulated 6-volt DC 2-amp power supply (not
included).
To purchase a power supply, call
your local Sears store. To avoid damaging
the console, use only a manufacturer-sup-
plied power supply.
Plug one end of the power
supply into the jack on the elliptical exerciser;
plug the other end into an outlet installed in
accordance with all local codes and ordinances.
11
11
Battery
C
over
B
attery
C
over