Filter
Top Products
5
M8 Split
Washer (97)–10
Wave Washer
(80)–2
M10 Nylon
Locknut (82)–2
#8 x 1/2"
Screw (81)–2
M10 Split
Washer (99)–4
Large Wave
Washer (89)–2
M8 x 40mm Button
Screw (90)–6
M8 x 20mm Patch
Screw (86)–4
M8 x 20mm Button
Screw (85)–4
M8 x 16mm Patch
Screw (84)–6
M8 x 23mm
Washer (31)–12
#8 x 1/2" Blunt
Screw (92)–9
#8 x 3/4"
Screw (78)–14
M8 x 58mm Button
Bolt (104)–2
M8 Nylon
Locknut (94)–2
M10 x 80mm Button Screw (93)–4
ASSEMBLY
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included hex keys and your own Phillips screwdriver , adjustable
wrench , and rubber mallet .
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses
below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number
following the parentheses is the quantity needed for assembly. Note: Some small parts may have been pre-
assembled. If a part is not in the hardware kit, check to see if it has been preassembled.