Filter
Top Products
11
14. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical exerciser.
12. Apply a generous amount of grease to the
axle on the Left Upper Body Leg (24). Then,
apply grease to a Large Wave Washer (89).
Slide an Upper Body Leg Spacer (9) and a
Large Wave Washer (89) onto the Left Upper
Body Leg (24). Make sure that the flat side of
the Upper Body Leg Spacer is facing out-
ward.
At the same time, slide the left Pedal Arm (32)
onto the Left Upper Body Leg (24) and insert
the left Link Arm (30) into the left Link Arm
Bracket (107).
Apply a small amount of grease to an M10 x
58mm Patch Bolt (104) and to the left Link Arm
Bracket (107). Attach the Link Arm (30) to the
Link Arm Bracket with the Patch Bolt, an M8 x
23mm Washer (31) and an M8 Nylon Locknut
(94).
Then, attach the Pedal Arm (32) to the Left
Upper Body Leg (24) with an M8 x 20mm Patch
Screw (86), an Axle Cover (66), and an M8 x
23mm Washer (31).
Repeat this step for the right Pedal Arm (32)
and the right Link Arm (30).
See step 4. Tighten the M8 x 20mm Button
Screws (85).
12
9
30
30
32
89
66
107
104
31
86
24
Grease
31
94
32
13. Tighten an Adjustment Knob (52) onto an
Adjustment Pin (101).
Repeat this step for the other Adjustment
Knob (not shown) and the other Adjustment
Pin (not shown).
Note: See HOW TO ADJUST THE STRIDE OF
THE ELLIPTICAL EXERCISER on page 13 and
make sure that the right and left sides of the ellip-
tical exerciser are adjusted to the same stride
length.
13
52
101
Grease