Filter
Top Products
15
29. Wrap the High Cable (73) around a 4” Pulley
(35). Attach the Pulley and a Cable Trap (44) to
the top hole in the Pulley Bracket (91) attached to
the Leg Press Cable (76), with a 3/8” x 1 3/4”
Bolt (60) and a 3/8” Nylon Jamnut (63).
30. Route the High Cable (73) up through the next
slot in the Top Frame (1) and wrap the Cable
around a 4” Pulley (35) in the direction shown.
Attach the 4” Pulley (35) to the Top Frame (1)
with a 3/8” x 2 1/2” Bolt (54), two 3/8” Washers
(55), two 5/8” x 1/2” Bushings (42), and a 3/8”
Nylon Jamnut (63).
29
30
44
63
73
73
1
35
63
55
55
42
35
31. Route the High Cable (73) around a 4” Pulley
(35) and down through the indicated slot in the
Top Frame (1).
Attach the 4” Pulley (35) to the Top Frame (1)
with a 3/8” x 2 1/2” Bolt (54), two 3/8” Washers
(55), two 5/8” x 1/2” Bushings (42), and a 3/8”
Nylon Jamnut (63).
Let the High Cable (73) hang over the weight
stack; it will be attached in step 38.
31
42
42
35
54
55
55
63
73
1
60
76
91
32. Locate the Low Cable (72), which has a ball on
each end. Route the Low Cable through the slots
in the Leg Lever (29) and the Base (8).
Attach a 4” Pulley (35) inside the Leg Lever (29)
with a 3/8” x 2 1/2” Bolt (54), two 3/8” Washers
(55), two 5/8” x 1/2” Bushings (42), and a 3/8”
Nylon Jamnut (63).
Attach the 1/2” x 1 3/4” Bushing (94) inside the
bottom of the Leg Lever (29) with a 5/16” x 2 1/2”
Bolt (96), two 5/16” Washers (80), and a 5/16”
Nylon Jamnut (79). Press a 2” Square Inner Cap
(33) into the bottom of the Leg Lever. Note: It
may be easier to attach the 2” Square Inner
Cap if you pivot the Leg Lever upward.
32
55
42
42
72
29
8
63
79
80
94
33
80
96
55
54
35
54