Filter
Top Products
9
If you purchase the optional chest pulse sensor (see page 23), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
1. Make sure that the key is removed from the console
and that the power cord is unplugged. Remove the in-
dicated 3/4” Screw (7) and the Access Door (95) from the
left side of the Console Back (96).
2. Connect the wire on the receiver (A) to the indicated wire
extending from the Console Back (96).
Hold the re-
ceiver so the small cylinder is oriented as shown and
is facing the Console Back.
Attach the receiver to the
plastic posts on the Access Door (95) with the two in-
cluded small screws.
3.
Make sure that no wires are pinched. Reattach the
Access Door (95) with the 3/4” Screw (7). Discard the
other wires included with the receiver.
A
96
Small
Cylinder
7
95
Wire
Small
Screws