Filter
Top Products
4
8
4
2
3
1
5
7
1. ON/OFF Power Button Switch
2. Left & Right Eyepieces with Rubber eyecups*
3. Manual Brightness Control (override) of displays.
4. Digital Zoom Button Switch
5. Universal Service Connector (see details on page 4)
6. Front lens with Focusing Ring
7. “Black hot-white hot” Button Switch (“BH-WH”)
8. Battery Compartment Cover
9. Dioptric Adjustment Rings.
*Interpupillary adjustments between eyes. Slide<-> or >-<
6
External Power Pack.
Very convenient for long time or cold weather operation.
Comes with high capacity Li-Ion batteries and universal
charger. Good for up to 8 hours of continuous work.
Caution! When external battery pack is in use strictly
recommended to remove 2 pcs. of AA batteries from
battery compartment. Leaving them inside will cause
overheating of the device and/or batteries which would
cause batteries leakage and power drain from the exter-
nal battery pack. Battery Pack has red LED which is ON
when connected to TVS 7B. Universal 110-250 V
charger is included.
Description
IMPORTANT NOTICE. USE OF IMPROPER
BATTERIES OR VOLTAGE MAY SERIOUSLY
DAMAGE DEVICE WITH NO WARRANTY
COVERAGE FROM US!
9
9
5
How To Do It
This is the short description how to operate TVS 7B.
Read carefully to make sure you fully understand how to
power up your Thermal Imager properly.
TVS 7B needs minimum 2.4 V and Maximum 3.3
V, therefore Use only Lithium type 2 pcs. AA batteries
(1.5V each) or at least 2500 mAh Rechargeable batteries
AA size (1.2V each).
To begin with, install batteries into battery compartment
(8) complying with polarity guidance (-)inside, (+)outside.
Remove cover from the front lens and switch Power But-
ton into position ON. Clicking sound in the beginning of
usage is normal for thermal core. By turning and moving
Dioptric Adjustment rings (9) adjust diopters and dis-
tance between eyepieces to satisfy the user eyes’ visual
acuity for the system’s best performance. Observing the
object adjust focus by turning front lens (6).
With optional Video-Out-to USB adapter and soft-
ware the video signal from Thermal Imager can be trans-
ferred to the computer and stored for tactical purposes.
Video-Out cable.
Allows to connect TVS 7B to any standard RCA Video-
In (monitor, TV, VCR etc.)
Video-Out-to USB adapter and software.
Allow to transfer images into digital format for further
transfer to a computerized fire control system.
NOTE. All technical description and features of the product are subject to
change without prior notice.
A
TTENTION! DO NOT POINT THE TURNED ON DEVICE
TO THE BRIGHT LIGHT SOURCE! IN SOME CASES LIGHT
OVERLOAD MAY CAUSE IRREVERSIBLE REDUCTION OF I.I.T. OR
F.P.A. RESPONSIVITY OR PERMANENT DAMAGING.