Filter
Top Products
15
FIGURE 6. Helmet mount
1. Locking screw
2. Flip/flop button
3. Flip-flop adjusting screws
4. Mount binding screw
1
2
3
4
The unit is fixed to the mount by the locking screw (1,
Fig. 6). To adjust the position of the unit to your eye level
use the screw (4, Fig. 6). To adjust the eye relief first
loosen the locking screw (1, Fig.6) and set a comfortable
distance between the eyes and the eyepiece; then tighten
the locking screw back.
You can fixate the unit in three predetermined positions: vertical,
horizontal, and 15-20 degrees above horizontal. Although the
relative angles between these positions cannot be changed, the
starting point can be adjusted by screws (3, Fig.6). If you loosen
them, you can rotate the flip-flop mechanism to find the suitable
starting point. Tighten the screws (3, Fig.6) after the adjustment.