Filter
Top Products
34
E3 – Elevation Stall
N
Y
N
N
Y
Y
E3 Error
Enter Hardware Test Screen
Run Elevation Up And Down
Treadmill
moves up or
down?
Waiting the Elevation
Motor to cool
Position Feedback Problem
Motor
Overheated?
Motor Movement Issue
Feedback
Changes
Elevation
AUTO-Calibration
Step 1. Please refer the below PROBLEM IDENTIFICATION Step.
Step 2. CORRECTIVE ACTION
1.Allow elevation motor to cool.
2.Check the failed system with a known good console cable. If fixed then
repair/replace the console cables.
3.Check the failed system with a known good elevation motor. If problem fixed then
repair/replace the elevation motor.
4.Check the failed system with a known good interface board (MCB). If problem
fixed then repair/replace the interface board (MCB).
5.Check the failed system with a known good console board with current software. If
the problem is fixed then repair/replace the console.
Check the “P13 ELV
DIRECTION” screen
whether set to “Yes”
Set to “Yes”
AUTO-
Calibration