Filter
Top Products
A
RCTIC
T
HUNDER
7
C
HAPTER
1 O
PERATION
TYPICAL REAR DOOR HASP INSTALLATION
14. Modify the lock plate at the top of the rear door. Remove the bolts and nuts from the lock plate, then
rotate the plate so that the slot will be above the door. Reinstall the bolts and nuts and tighten firmly.
15. Reinstall the rear door onto the cabinet and close it. Lock the rear door and remove the key. If
required, install the extra padlock through the hasp at this time. Install the screws at the top and sides
of the rear door and tighten snugly. Leave the remaining doors open at this time.
LINE CORD INSTALLATION
16. The power cord is packed in with the spare parts. Insert a portion of the line cord in the cord clamp
leaving enough slack for the cord. Match the holes on the IEC plug with the prongs in the receptacle
and push firmly to seat the line cord.
17. Plug the game into a grounded (3-terminal) AC wall outlet. Switch on power to the game using the ON/
OFF switch located on the upper left top of the cabinet (when viewed from the player’s position). The
game will power up and begin its self test. If no errors are found, the game will automatically enter the
attract mode of operation (scenes and sounds from typical races, player’s scores, messages, etc.).
18. Open the coin door. Press and hold the Begin Test button on the operator control switch panel to enter
the menu system. Wait until the Main Menu screen appears on the monitor.