Filter
Top Products
S
ERVICE ACCESS PORT
The two interchangeable type RJ45 networking ports (A) are located on the back of the display
console. These network ports, located behind the display console rear access door, allow for
console software updates.
POWER CORD ROUTING
The power cord can be run straight from the treadmill, shortened and exited out the user-front
left side, or run under the frame using the power cord clips and exited out the user right-rear
side of the treadmill.
For efficient cord management, the following routing options are recommended:
With the power cord unplugged, insert the clips in the appropriate holes. See the illustration
below. Use Hole Pattern 1 or 2 to locate the clips and secure the power cord with the clips,
taking up any slack between clips.
NOTE: It may be necessary to tip the treadmill to route the power cord properly.
To plug the power cord into an outlet in front of the treadmill, use Hole Pattern 1 for outlets
located at the front of the machine.
NOTE: To accomodate treadmill incline, at least two feet (24”) of power cord is required
between the outlet and the last power cord clip for outlets in front of the treadmill.
A
12