Filter
Top Products
5. Locate a BOTTOM HANDRAIL SPACER (#8). Slide the BOTTOM
HANDRAIL SPACER onto the bottom of the USER RIGHT HANDRAIL (#4)
with the flat side of the BOTTOM HANDRAIL SPACER facing the FRAME
(B). Align the two mounting holes in the HANDRAIL, BOTTOM HANDRAIL
SPACER, and FRAME and insert two LONG MOUNTING BOLTS (#7) and
tighten securely using a 5/32” hex key wrench.
6. After securing the USER RIGHT SIDE HANDRAIL (#4) to the USER
RIGHT UPRIGHT (#2), remove the USER LEFT UPRIGHT rear
mounting bolt and carefully twist THE USER LEFT UPRIGHT (#1)
outward until the rear mounting flange is off of the FRAME (B).
NOTE: BE CAREFUL NOT TO TILT THE USER LEFT
UPRIGHT (#1) FROM UNDER THE DISPLAY CONSOLE (#3) WHEN
TWISTING THE USER LEFT UPRIGHT OUTWARD.
REMARQUE : VEILLER À NE PAS INCLINER LE MONTANT DE GAUCHE
(Nº 1) SOUS LA CONSOLE D’AFFICHAGE (Nº 3) LORS DE SON
ORIENTATION VERS L’EXTÉRIEUR.
7. Reach a finger up into the ACCESS HOLE (E) located under the USER
LEFT UPRIGHT mounting flange and guide the 10-PIN CONNECTOR (10P)
of the WIRE HARNESS (C) that was fed into the USER LEFT UPRIGHT
through the BOTTOM CABLE ROUTING HOLE (F) of the USER LEFT
UPRIGHT. Carefully pull the excess wire from within the USER LEFT
UPRIGHT. Plug the 10-PIN CONNECTOR into the CONTROL BOARD (G)
located in the MOTOR COMPARTMENT (H). Feed any excess wire back into
the USER LEFT UPRIGHT.
NOTE: BE CAREFUL NOT TO DAMAGE THE WIRE
HARNESS (C) WHEN PULLING IT THROUGH THE BOTTOM CABLE
ROUTING HOLE (F) IN THE USER LEFT UPRIGHT (#1).
REMARQUE : VEILLER À NE PAS ENDOMMAGER LE FAISCEAU DE
CÂBLES (C) LORS DE SON PASSAGE DANS L’ORIFICE
D’ACHEMINEMENT DE CÂBLES INFÉRIEUR (F) DU MONTANT DE
GAUCHE (Nº 1).
8. Carefully twist the USER LEFT UPRIGHT back into position on the FRAME
(B) and re-insert the rear MOUNTING BOLT (#10). Tighten the BOLT using a
9/16” combination wrench until snug and then back it off 1/4 turn.
NOTE: BE CAREFUL NOT TO DAMAGE THE WIRE
HARNESS (C) WHEN TWISTING THE USER LEFT
UPRIGHT (#1) BACK INTO POSITION.
REMARQUE : VEILLER À NE PAS ENDOMMAGER LE FAISCEAU
DE CÂBLES (C) LORS DE LA REMISE EN PLACE DU MONTANT DE
GAUCHE (Nº 1).
9. Repeat Steps 4 and 5 to assemble the USER LEFT HANDRAIL.
Tighten all mounting bolts and then back them off one full turn.
7
C
1
10P
G
H
F
B
4
7
8
C F10P
1
E
B
1
D
3
B