Life Fitness T7i Treadmill User Manual


 
IMPORTANT!
DO NOT DISCARD THE SHIP KIT LOCATED ON TOP OF THE DECK AND BELT. ALL NECESSARY COMPONENTS NEEDED TO
COMPLETE THE INSTALLATION ARE LOCATED IN THE SHIP KIT AND BASE TRAY.
1. Remove the tape securing the MOTOR COVER (A) to the FRAME (B).
Carefully lift and remove the MOTOR COVER.
2. Remove the USER LEFT UPRIGHT (#1) (with grommets installed) from the
BASE TRAY. With the USER LEFT UPRIGHT angled toward the rear of the
unit, align the mounting holes of the flanged end of the USER LEFT
UPRIGHT with those on the top of the FRAME (B). Using two BOLTS (#10),
secure the USER LEFT UPRIGHT to the FRAME. Tighten the BOLTS using
a 9/16” combination wrench until snug and then back them off 1/4 turn.
Repeat the procedure for the USER RIGHT UPRIGHT (#2).
3. Locate the DISPLAY CONSOLE ASSEMBLY (#3). Unwrap the WIRE
HARNESS (C) secured to the back of the DISPLAY CONSOLE ASSEMBLY.
Standing at the front of the unit, carefully lower the DISPLAY CONSOLE
ASSEMBLY down near the tops of the USER LEFT and RIGHT UPRIGHTS
(#1 & #2). Lower the user right side of the DISPLAY CONSOLE ASSEMBLY to
rest on the USER RIGHT UPRIGHT. Holding the user left side of the DISPLAY
CONSOLE ASSEMBLY slightly above the USER LEFT UPRIGHT, feed the
WIRE HARNESS down into the USER LEFT UPRIGHT through the TOP
CABLE ROUTING HOLE (D) of the USER LEFT UPRIGHT. Once the WIRE
HARNESS is completely inserted into the USER LEFT UPRIGHT, lower the
DISPLAY CONSOLE ASSEMBLY to completely rest on the USER LEFT
UPRIGHT.
NOTE: BE CAREFUL NOT TO DAMAGE THE
WIRE HARNESS (C) WHEN ROUTING IT THROUGH THE
USER LEFT UPRIGHT (#1).
REMARQUE : VEILLER À NE PAS ENDOMMAGER LE FAISCEAU DE
CÂBLES (C) LORS DE SON PASSAGE PAR LE MONTANT
DE GAUCHE (Nº 1).
NOTE: BE CAREFUL NOT TO PINCH THE WIRE HARNESS (C) WHEN
LOWERING THE DISPLAY CONSOLE ASSEMBLY (#3) ONTO THE USER
LEFT UPRIGHT (#1).
REMARQUE : VEILLER À NE PAS PINCER LE FAISCEAU DE CÂBLES
(C) LORS DE L’ABAISSEMENT DE LA CONSOLE D’AFFICHAGE (Nº 3)
SUR LE MONTANT DE GAUCHE (Nº 1).
4. Locate a HANDRAIL (#4) and a TOP HANDRAIL SPACER (#5). Insert a
LONG MOUNTING BOLT (#7) through the bottom most of the two top
mounting holes of the HANDRAIL as shown. Slide a TOP HANDRAIL
SPACER over the LONG MOUNTING BOLT as shown (flat side facing the
upright and cutout facing downward) until it fully nests over the HANDRAIL.
Align and insert the same LONG MOUNTING BOLT into the bottom most
mounting hole of the USER RIGHT UPRIGHT (#2). Tighten the bolt until
snug and then back it off one full turn. Insert a LONG MOUNTING BOLT
(#7) through the remaining (upper) mounting hole and tighten the two bolts
securely using a 5/32” hex key wrench.
6
A
B
1
B
10
3
C
1
D
5
7
4
2