Filter
Top Products
SM80 Unpacking & Assembly Instructions
7
Figure 6. Configuration for 2-3/4” and 3” bolts.
3. Bolt on the connecting beam (part 4 from Figure 2) using a 5/8” socket with
extension and combination wrench, to the cubes using two of the large 7/16” x 6”
bolts, 7/16” washers, and 7/16” nuts, end cap washers and end caps. Figure 7 shows
the connected cubes.
7/16” x 6” (8)-
mount on tops
3/8” x 3” (4)-
bolt top
beams together
T
T
U
U
Remove pulleys from
housings to give clearance
to socket extension
Figure 7. Bolt on the connecting beam, lat tops, tricep tops.
4. Mount the 56” lat tops (part T) to the cells using a 5/8” socket and combination
wrench by inserting two of the large 7/16” by 6” bolts using the hardware configuration
shown. Mount the 29” tricep tops (part U) to the frame and connecting beam (See
Figure 7). Use the hardware configuration shown. You will need to remove the pulleys
from the teardrop pulley assemblies to gain clearance for the socket wrench
extension. Leave the pulleys out of the housings until the cables have been installed.