Filter
Top Products
4
3. Attach one ROLLER PAD (10) to a CENTER FRAME SHAFT (C) using ONE
PLATE (11), M10 x 25mm BOLTS (7) and BEARING CAP (12). Tighten the
BOLTS securely.
Repeat for the remaining ROLLER PAD (10).
4. Attach the ANGLE PADS (13) to the WAIST FRAME (6) as shown using six
M10 x 25mm BOLTS (7) and FLAT WASHERS (4). Tighten the BOLTS
securely.
5. Snap the GAS SPRING (14) to the CENTER FRAME (2) and WAIST FRAME
(6) as shown.
Be sure the GAS SPRING snaps securely to the mounting posts.
Back Extension
1. Assembly Instructions