Filter
Top Products
1. Attach the FRONT FOOT (1) to the CENTER FRAME (2) using two M10 x
135mm BOLTS (3), FLAT WASHERS (4), and NYLOCK NUTS (5). Tighten
the BOLTS and NUTS securely.
2. With the WAIST FRAME (6) positioned as shown, carefully slide the
WAIST FRAME into the CENTER FRAME (2). Pull the POSITIONING PIN
(A) upward to allow the WAIST FRAME to slide past. Release the POSI-
TIONING PIN and allow the pin to engage the WAIST FRAME.
Slide the GLIDE CAP (B) downward and into the top of the CENTER
FRAME (2). Secure the GLIDE CAP using two M10 x 25mm BOLTS (7) and
SPACERS (8). Tighten the BOLTS securely.
Insert the SMALL HOLE PLUG (9) into the access hole located opposite
the POSITIONING PIN (A)
3