Filter
Top Products
8. Attach the 4-PI
N
(4P) and 16-PI
N
(16P) CO
NNECTORS
to the
corresponding JA
CKS
on the back of the CO
NSOLE
AS
SEMBLY
(4).
9. Feed any excess WIRE HARNESS (E) down into the CONSOLE
SU
PPORT
AS
SEMBLY
(7). Secure the CO
NSOLE
AS
SEMBLY
(4) to the
CO
NSOLE
SU
PPORT
AS
SEMBLY
using four PH
ILLIPS
PA
N
HE
AD
SC
REWS
(2). Tighten the SC
REWS
securely.
CAUTION: Do not over-tighten the PHILLIPS PAN HEAD
SCREWS (2).
CAUTION: Be careful not to pinch the WIRE HARNESS (E) when
assembling the CONSOLE ASSEMBLY (4) to the CONSOLE SUPPORT
ASSEMBLY (7).
10. Locate and install the CO
NSOLE
SU
PPORT
CA
P
(19) onto the
CONSOLE SUPPORT ASSEMBLY (7) as shown using four CAP
SCREWS (21).
11. Place the BA
CK
MO
NOCOLUMN
CO
VER
(6) over the PI
VOT
SH
AFT
(H)
at the top of the MO
NOCOLUMN
(F).
12. Place the FRONT MONOCOLUMN COVER (5) on the opposite side of
the BACK MONOCOLUMN COVER (6) to cover the PIVOT SHAFT (G)
and CONSOLE SUPPORT ASSEMBLY MOUNTING SCREWS. Interlock the
top tabs and use two PH
ILLIPS
PA
N
HE
AD
PO
INTED
SC
REWS
(3) to
secure the bottoms of the MONOCOLUMN COVERS together.
Tighten the SCREWS securely.
CAUTION: Do not over-tighten the PHILLIPS PAN HEAD POINTED
SCREWS (3).
13. Locate one FRONT ROCKER COVER (13) and one BACK ROCKER
COVER (14). Position the FRONT ROCKER COVER over the user
side of the left end of the PIVOT SHAFT (H) (as shown) making
sure that it interlocks with the MONOCOLUMN COVERS (5 & 6).
Place the BACK ROCKER COVER over the opposite side of the left
end of the PIVOT SHAFT in the same manner. Secure the COVERS
using three PHILLIPS PAN HEAD POINTED SCREWS (3). Repeat the
procedure reversing front and back for the user right end of the
PIVOT SHAFT.
CAUTION: Do not over-tighten the P
HILLIPS PAN HEAD POINTED
SCREWS (3).
14
13
5
H
F
G
6
3
14
13
3
4P
16P
21
4
3
23
19
2
1
7
F
E
17
20
22
8
6