Filter
Top Products
Slide the ACCESSORY TRAY (#8) (if so
equipped) over the user right seat back post
and down to make contact with the SEAT
HANDLEBAR.
Position the underside clamp bracket (A)
around the SEAT HANDLEBAR and tighten
the two clamp SCREWS and WASHERS(B).
NOTE: BE CAREFUL NOT TO OVER-TIGHTEN
THE SCREWS.
Align the four holes in the SEAT BACK (#5)
with those in the SEAT BACK POSTS. Insert
the four SCREWS (#1) and WASHERS (#2)
through the backside of the SEAT BACK
POSTS and into the SEAT BACK. Tighten the
four SCREWS with a hex key wrench.
NOTE: BE CAREFUL NOT TO OVER-TIGHTEN
THE SCREWS.
Unfold the two CONSOLE WIRE
HARNESSES (C) from the POST extending
from the FRAME.
Feed the two WIRE HARNESSES at the top
of the FRAME POST through the bottom of
the HANDLEBAR ASSEMBLY COLUMN.
Continue pushing the WIRE HARNESSES
until the CONNECTORS at the end of the
WIRE HARNESSES exit through the opening
at the top of the COLUMN. Gently pull the
WIRE HARNESSES to remove the slack.
Position the HANDLEBAR ASSEMBLY (#6)
so that the HANDLEBAR is facing the user
and slide the HANDLEBAR ASSEMBLY into
the FRAME POST (D), being careful not to
pinch the WIRES in the process. Align the
holes in the top of the HANDLEBAR
ASSEMBLY with those in the FRAME POST.
Install the two HANDLEBAR BOLTS (#3) to
secure it into position.
NOTE: BE VERY CAREFUL NOT TO DAMAGE
THE WIRES WHEN PASSING THE BOLTS
THROUGH THE HOLES. TIGHTEN THE BOLTS
SECURELY.