Life Fitness Lifecycle 9100 Bicycle User Manual


 
Step 7
Slide the COLLAR (#4) down until it completely covers the HANDLEBAR
ASSEMBLY HARDWARE and the HANDLEBAR POST. Secure the COLLAR by
squeezing the sides and pushing downward firmly.
Step 8
There is a large hole in the rear of the DISPLAY CONSOLE (#6) through which
you can see a 16-PIN CONNECTOR and a 3-PIN CONNECTOR. These
correspond to the matching CONNECTORS on the WIRE HARNESS protruding
from the top of the HANDLEBAR.
Properly align the locking tabs of the 16-PIN CONNECTOR on the WIRE
HARNESS with the 16-PIN CONNECTOR on the back of the DISPLAY
CONSOLE, then snap them together. Next, align the locking tabs of the
3-PIN CONNECTOR on the WIRE HARNESS with the 3-PIN on the back
of the DISPLAY CONSOLE and plug them together until they SNAP into
place.
Step 9
Feed the WIRE HARNESS back into the HANDLEBAR TUBE. Attach
the DISPLAY CONSOLE to the HANDLEBAR ASSEMBLY using the
four CONSOLE SCREWS (#2) and a Phillips screwdriver. Tighten the
four SCREWS in a crisscross pattern.
CAUTION!: BE CAREFUL NOT TO OVERTIGHTEN THE SCREWS.
Step 10
To install the 9-VOLT ALKALINE BATTERY (#8) found in the parts bag use a Phillips screwdriver to remove the screw
from the back door. Gently pull the BATTERY WIRES from the back of the DISPLAY CONSOLE and connect them to
the 9-VOLT ALKALINE BATTERY.
Carefully, tuck the BATTERY
WIRES back into the DISPLAY
CONSOLE and set the BATTERY in
place.
Re-install the BATTERY DOOR by
inserting the bottom tab of the
BATTERY DOOR into the
corresponding slot in the DISPLAY
CONSOLE. Push the DOOR into
place and tighten the screw with a
Phillips screwdriver.
CAUTION!: BE CAREFUL NOT TO OVER TIGHTEN THE SCREW
Step 11
After placing the Lifecycle exercise bike in the intended location for use, check
the stability of the bike.
If the bike is not level, rotate the FOOT in the STABILIZER BAR that appears to
be higher until the Lifecycle exercise bike is level.
Secure the position of the FOOT by tightening the LOCKNUT with the enclosed
wrench.
NOTE: ONLY USE AN ALKALINE TYPE BATTERY. USE OF ANY OTHER TYPE
BATTERY MAY RESULT IN A MALFUNCTION OR DAMAGE.