Filter
Top Products
Step 7
Slide the COLLAR (#4) down until it completely covers the
HANDLEBAR ASSEMBLY HARDWARE and the HANDLEBAR
POST (D). Secure the COLLAR by squeezing the sides and
pushing firmly downward.
Step 8
There is a large hole in the rear of the DISPLAY CONSOLE
(#6) through which you can see a 16-PIN CONNECTOR (16P)
and a 3-PIN CONNECTOR (3P). These correspond to the
respective CONNECTORS on the WIRE HARNESS protruding
from the top of the HANDLEBAR.
Properly align the locking tabs of the 16-PIN
CONNECTOR (16P) on the WIRE HARNESS with the 16-
PIN CONNECTOR on the back of the DISPLAY
CONSOLE, then snap them together. Next, align the
locking tabs of the 3-PIN CONNECTOR (3P) on the WIRE
HARNESS with the 3-PIN on the back of the DISPLAY
CONSOLE and push them together until they SNAP into
place.
Step 9
Feed the WIRE HARNESS back into the HANDLEBAR
TUBE. Attach the DISPLAY CONSOLE to the
HANDLEBAR ASSEMBLY using the four CONSOLE
SCREWS (#2) and a Phillips screwdriver. Tighten the four
SCREWS in a crisscross pattern. 1 4
2 2
CAUTION!: BE CAREFUL NOT TO OVERTIGHTEN THE SCREWS.
Step 10
To install the 9-VOLT ALKALINE BATTERY (#8) found in the parts bag use a Phillips screwdriver to remove the
screw from the BATTERY DOOR (E). Gently pull the BATTERY WIRES (F) from the back of the DISPLAY
CONSOLE and connect them to
the 9-VOLT ALKALINE BATTERY.
Carefully, tuck the BATTERY
WIRES back into the DISPLAY
CONSOLE and set the BATTERY
in place.
Re-install the BATTERY DOOR by
inserting the bottom tab of the
BATTERY DOOR into the
corresponding slot in the DISPLAY
CONSOLE. Push the DOOR into
place and tighten the screw with a
Phillips screwdriver.
CAUTION!: BE CAREFUL NOT TO OVER TIGHTEN THE SCREW
NOTE: ONLY USE AN ALKALINE TYPE BATTERY. USE OF ANY OTHER TYPE
BATTERY MAY RESULT IN A MALFUNCTION OR DAMAGE.