Filter
Top Products
Step 1
Before proceeding, familiarize yourself with the parts of the Lifecycle 8500 exercise bike and make sure that you
have received all the items described in the Parts List.
Step 2
Remove the STABILIZER BAR (#7) from the
carton base. Use the empty CONSOLE
CARTON (A) to raise the rear of the Lifecycle
bike as shown.
Remove the two BOLTS (#1) from the bottom
of the SHIPPING STABILIZER (B), save the
BOLTS and store the SHIPPING STABILIZER
with the other shipping containers.
Step 3
Use the same two BOLTS that held the
SHIPPING STABILIZER in place to attach the
STABILIZER BAR as shown. Make certain
that the BOLTS are very tight and the
STABILIZER BAR is flush against the frame.
Remove the shipping carton.
Step 4
Unfold the CONSOLE WIRE HARNESS (C)
from the HANDLEBAR POST extending from
the FRAME.
NOTE: THE COLLAR (#4) SHOULD ALREADY BE IN PLACE INSTALLED ON THE
HANDLEBAR ASSEMBLY (#5). IF NOT, INSTALL BEFORE PROCEEDING.
Step 5
Place the HANDLEBAR ASSEMBLY on the floor in front of the
FRAME with the two CONNECTORS (10P) next to each other.
Align the two CONNECTORS with each other and firmly push
them together until they snap into place.
Step 6
Position the HANDLEBAR ASSEMBLY, with the COLLAR (#4)
in place, so that the HANDLEBAR is facing away from the seat.
Slide the HANDLEBAR ASSEMBLY into the HANDLEBAR
POST (D). Be careful not to pinch the wires.
Align the three holes in
the HANDLEBAR
ASSEMBLY with those
in the HANDLEBAR
POST and install the
three HANDLEBAR
BOLTS (#1).
NOTE: BE CAREFUL NOT TO DAMAGE THE WIRES WHEN PASSING
THE BOLTS THROUGH THE HOLES. TIGHTEN THE BOLTS
SECURELY.