Filter
Top Products
15
STEP 9:
Make adjustments to the HEAD PLATE PULLEY (19) and the threaded cable end to adjust cable length and to
ensure the cable is taut.
If the threaded cable end is completely threaded into the ROLLER CARRIAGE (Q) and there is still some slack in
the CABLE (21), remove the pulley from the HEAD PLATE PULLEY (19). Thread the HEAD PLATE PULLEY (19)
further into the TOP PLATE ASSEMBLY (18) and reinstall the pulley.
NOTE: IF REMOVING THE PULLEY, REMOVE THE M10 x 50mm SCREW , PULLEY RETAINER, M10 SOCKET
HEAD NUT, and PARTIAL PULLEY COVERS.
Once the CABLE (21) is taut, engage the jam nut at the threaded end of the cable as well as at the HEAD PLATE
PULLEY ASSEMBLY (19).