Filter
Top Products
965101 FLAT & INCLINE BENCH ASSEMBLY INSTRUCTIONS
1.
Slide one (1) 7/]L6 ~ X 4 ~ ~ C~ onto ~e 6-1/8 X 3-7/8 ~ U-P~ ~d proceed to am;emble it
~e BENC~ FR~ ~LD~NT ~ sho~ on ~w~g.
Insert two (2) 3 X 2 INSERT GUIDES into each end of the ADJ SLEEVE WELDMENT as .,;hoxvn
drawing. (NOTE: MAKE SURE THE INSERT GUIDES S NAP INTO THE HOLES OF THE
WELDMENT).. SECURELY assemble the SPRING PIN ASSEMBLY to the ADJ SLEEVE
WELDMENT as shown in (DETAIL A).
Pull back the SPR.ING PIN on the ADJ SLEEVE WELDMENT and slide it over the end of ~ae BENCH
FRAME WELDMENT ,as shown on drawing. Slide WELDMENT up to the f’ast adjustmenl
~.
hole
underneath.
o
Insert three (3)’3 X 2 IN END CAPS into the ends of the REAR UPRIGHT WELDMENT a:; shown
drawing.
SECURELY a.~;semble the REAR UPRIGHT WELDMENT to the BENCH FRAME WELDMENT as
shown on drawing.
Assemble the LEFT and RIGHT BACK PAD ANGLE WELDMENTS, along with two (2) HINGE
TABS to the BENCH FRAME WELDMENT as shown on drawing. (NOTE: TIGHTEN
CONNECTION ENOUGH TO REMOVE TIlE PLAY YET ALLOWING THE PARTS TO
ROTATE FREELY).
7° Assemble t~vo (2) 1/2 X 2 X 15-1/2 IN PLATES to the inside of the LEFT and RIGHT BACK PAD
ANGLE WEL’I)MENTS as shown on drawing. (’NOTE: TIGHTEN CONNECTION ENOUGH
REMOVE "lille PLAY ~rET ALLOWING THE PARTS TO ROTATE FREELY).
Rotate the LEFT and RIGHT BACK PAD ANGLE WELDMENTS up and assemble the 1/2 X 2 X 15-
1/2 IN PLATES to the ADJ SLEEVE WELDMENT as shown on drawing. (NOTE: DO NOT OVER
TIGHTEN TI]~S CONNECTION).
Part # 6653501
3
Revision: 11/26/96