Filter
Top Products
11
STRIDE SENSOR AUTO-SHUTOFF SYSTEM
The Stride Sensor auto-shutoff system detects whether a user is on the belt/deck. If the user leaves the belt/deck during
a workout, the system is triggered and the following message is displayed, "User not detected on belt - press “OK” to
continue workout." If the user presses “OK” during this message the workout will continue without interruption. If the user
does not press “OK” another message will be displayed, "User not detected on belt; RESUME WORKOUT / EXIT
WORKOUT". At this point power to the belt will shut off as the treadmill enters Pause mode. If the user presses
RESUME WORKOUT during the second message the workout will be resumed. If the user does not press RESUME
WORKOUT, the treadmill will continue in Pause mode and eventually end the workout. This feature can be disabled in
the Manager's Configuration.
CABLE TV HOOK-UP
Note to the CATV Installer:
This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guide-
lines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system
of the building as close to the point of cable entry as practical.
NOTE: The TV aspect of the 15” LCD Console (95 Te) can only receive an analog signal. Digital cable must be external-
ly converted to an analog signal. Life Fitness is not responsible for the installation of CATV service or components
required for the delivery of CATV service. An external TV signal input via 75-ohm coaxial cable must be present before
TV setup can occur. .