Filter
Top Products
17
10. Attach the ADAPTER BRACKET (AA) to the ENTERTAINMENT
CONSOLE (k) to the using four SCREWS (BB). Tighten the
SCREWS to 6-8 in-lbs. Do not overtighten the SCREWS.
Attach the ENTERTAINMENT CONSOLE to the UPPER
MOUNTING PLATE (m) using four SCREWS (n) and WASHERS
(o). Tighten the SCREWS to 6-8 in-lbs. Do not overtighten the
SCREWS.
11. Connect the COAXIAL CABLE, POWER CORD and REMOTE
CABLE (g) to the rear of the ENTERTAINMENT CONSOLE (k) as
shown under Console Cable Connections at the end of this manual.
12. CABLE TIE (j) any excess cable together behind the ENTERTAINMENT
CONSOLE (k) and position the cables between the MOUNTING BRACKET (b) and the
DISPLAY CONSOLE (4).
13. Secure the POWER ADAPTER (p) to the FRONT STABILIZER (q)
using two CABLE TIES (j) as shown. Be sure the CABLE TIES are
pulled tight and trim the excess CABLE TIES. Connect the screw-type
connector of the POWER CORD (r) to the underside receptacle.
Bundle excess power cord and store under the unit. Connect the COAXI-
AL CABLE (s) to the broadcast supply receptacle in similar fashion.
14. Connect the POWER SUPPLY CORD to the POWER ADAPTER (p).
15. Continue with the remainder of assembly as instructed in the
Assembly Instructions. Plug the POWER SUPPLY CORD into
an electrical outlet upon completion.