Filter
Top Products
STEP 6:
FIGURE 6
7
STEP 7:
• SECURELY assemble two ROLLER PADS (17) to the KNEE SUPPORT (3) using one 21-1/2” TUBE
(14) and two 1-5/16” SHAFT COLLARS (32). SECURELY tighten set screws on SHAFT COLLARS
(32). See FIGURE 6.
• Pull back on SPRING PIN and slide KNEE SUPPORT (3) over square tube on BENCH FRAME (1) as
shown in FIGURE 7.
• SECURELY assemble the 3/8” SPRING PIN (29) to the SPRING PIN HOUSING on the KNEE
SUPPORT (3) as shown in FIGURE 7.
FIGURE 7
14
3
17
32
1
3
29