Filter
Top Products
NOTE: IF THE CABLE APPEARS TO BE TOO SHORT, MAKE SURE LEG PRESS IS ADJUSTED SO THE SEAT AND
FOOT PLATES ARE IN THEIR CLOSEST POSITION. THE DoRING CABLE ON THE 425 MAY ALSO NEED
TO BE ADJUSTED. --
NOTE:
IF THE 445101, 425 2ND STACK OPTION IS INSTALLED, AND THE REAR SttROUD IL*,S AN OVAL SLOT,
THE LEG PRESS CABLE WILL l~VE TO BE LOOPED THROUGH THE SLOT PRIOR TO FINISHING STEP
13.
14.
15.
Attach one (1) SHOCK CORD to the KEYHOLE CLEVIS on the end of the LEG PRESS CABLE, and rm~e the SHOCK
CORD up and around the sccond 2. IN. PULLEY above the D-RING and down to the BASK
Attach one (I) SWIVEL to the end ofd~c SHOCK CORD. Slip the end of the mvivcI over the 3/8 X 4-I/2 IN THREADED
SHAFT, and SECURE. in place with one (1) 3/8 IN. LOCK NUT.
16.
SECURELY attach the REAR SHROUD using four (4) 3/~ X 1 IN. BOLTS and lVour (,t) .3/8 IN. WASHERS.
17.
The 832 LEG PRESS OPTION is equipped with a SPRING PIN ADJUSTMENT to accommodate different sized users
and to allow caw entry and exit from thc machine. To use, you mu.~t slightly push agaimt the foot plates to take tension off
the pin. ¯
I2/2-