Filter
Top Products
REMOVE
STEP 6
Remove the existing CABLE (part #68331) using the following steps:
¯ Disconnect LAT BAR from TOP BOOM.
¯ Unscrew the threaded end of CABLE from the HEAD PLATE ASSEMBLY.
¯ Route the CABLE around the FLOAT~’G PULLEY as shown in FIGURE 6.
¯ Route the CABLE through the TOP BOOM as shown in FIGURE 6.
¯ The pulleys in TOP BOOM ma.v need to be temporarily removed to remove CABLE.
¯ (NOTE: Discard CABLE part ~q58331)
FIGURE 6