Filter
Top Products
- 2 -
Assembly
The best assembly results are achieved when the
ceiling brackets are located directly above the seat
and handlebars. Ensure there is sufficient clearance
from the side walls.
1. Measure the distance between the handlebars
and the seat on your bicycle.
2. Transfer this measurement to the ceiling,
marking the required drill-holes with the aid
of a ceiling bracket. Drill the required holes
and insert the plugs.
3. Make a stable square knot at one end of the
nylon cord and thread it through the rear
ceiling bracket (See Fig. 1).
4. Fasten both ceiling brackets to the ceiling with
the supplied cross-head screws and plugs
(see Fig. 1).
5. Connect the construction with the cord in ac-
cordance with the block and tackle principle.
Run the cord through the rollers in alternation,
starting at the ceiling bracket (see Fig. 3).
6. Run the cord through the safety mechanism in
the ceiling bracket. (see Fig. 2).
7. Check that all screws are firmly tightened
before using the bicycle hoist.
8. Assemble the wall mount. To do this, lift the
bicycle with the hoist and mark the position
for the wall mount.
9. After assembling the wall mount, check all
screw connections for tightness again.
Notice: Should the cord slip quickly through
your hands when raising or lowering the
bicycle, the increased tempo of the cord itself
will trigger the brake and the cord will stop
automatically.
Maintenance
Grease the rollers at regular intervals. This will
ensure that the bicycle hoist moves easily.
Disposal
Do not dispose of the device in normal domestic
waste.
Dispose of the device over a registered waste
disposal firm or through your communal waste
disposal facility.
Observe the currently valid regulations. In case
of doubt, consult your waste disposal facility.
Dispose of the packaging materials in an
environmentally responsible manner.
Importer
KOMPERNASS GMBH
BURGSTRASSE 21
D-44867 BOCHUM
www.kompernass.com
Service
DES Ltd
Units 14–15
Bilston Industrial Estate
Oxford Street
Bilston
WV14 7EG
Tel.: 0870 787 6177
Fax: 0870 787 6168
e-mail: support.uk
@
kompernass.com
IB_KH4056_GB_LB4 30.11.2007 12:26 Uhr Seite 2