Filter
Top Products
7
STEP 3
Install the Leg Developer (#7) to bracket of Leg Developer Holder
(#11) using one M10X75 Bolt (#32), two D10 Washers (#35), and
one M10 aircraft nut (#36),
Insert the Roller Foam Tube (#10) halfway into leg developer (#7).
Push Roller Foams (#18) on each side of roller tube (#10) to com-
plete leg develops assembly.
Insert the Leg Developer Holder (#11) into the opening top of the
Front Stand Tube (#8) through rect. Outer Plug (#16) and secure
with Knob Bolt (#15).
NOTE: Hand tighten bolts and nylon nuts until machine is fully assembled.
Assembly