Filter
Top Products
ASSEMBLY
STEP 1
NOTE: Hand tighten bolts and nylon nuts until machine is fully assembled.
Attach main base (1) to rear base (17) using:
2 x (47) Bolt
1 x (27) Plate
4 x (54) Washer
2 x (59) Nylon Locknut
STEP 2
Connect main support (2) to main upright (3)
using:
2 x (45) Bolt
2 x (54) Washer
Then connect to main base (1) using:
2 x (48) Bolt
4 x (54) Washer
2 x (59) Nylon Locknut
2 x (45) Bolt
2 x (54) Washer
Slide shaft (26) through pillow block bearings (61)
and main upright (3), secure using:
2 x (51) Bolt
4 x (55) Washer
2 x (60) Nylon Locknut
Insert stopper slide (8) into the main upright (3)
and then attach air cylinder (22) to main upright
(3) and stopper slide (8).
Y