Filter
Top Products
7
Figure 3: Right Upright Installation
3. Locate the right upright. Connect the
console harness together. One side of har-
ness is located near the motor cover on
the bottom right side. The other end is
located inside the right upright.
Slide the right upright onto the base
frame. Secure the right upright to the
base frame by using four bolts M10x25
and four washers 10.
Assembly
Bolt M10x25
Washer 10
Console
Harness
Figure 4: Cross Bar Installation
4. Locate the cross bar. Slide the cross
bar in between the left and right uprights.
Secure the cross bar using one washer M8
and one bolt M8x57 on each side.
Cross Bar
Washer M8
Bolt M8x57
Note: Make sure that the console har-
ness is inside of the upright and not being
pinched.