Filter
Top Products
15
5K RUN AND 10K RUN (P5 - P6)
Pre-set programs will allow user to workout for a preset DISTANCE of 5K (3.1 Miles) and 10K
(6.2 Miles). Once the pre-set DISTANCE is reached, the treadmill will enter Cool Down.
1. Press PROGRAM UP button or PROGRAM DOWN button until P5, 5k run, or P6, 10k run, is
selected. Press ENTER. The SPEED window will blink. Use the SPEED + or – arrows or tog-
gles to select your workout SPEED. Press ENTER.
2. The INCLINE window will then blink. Use the INCLINE + or – arrows or incline toggles to set
your workout incline. Press ENTER.
3. To start, press the START/STOP button.
PROGRAMS (P7 - P13)
These are pre-set programs with predefined values.
1. Press PROGRAM UP or PROGRAM DOWN until desired program is selected.
2. The TIME window will blink. Use the SPEED + or - arrows or toggles to select your workout
TIME. Press ENTER.
3. The SPEED window will then blink. Use the SPEED + or – arrows or toggle to select the
speed for your workout. Press ENTER.
4. To start, press the START/STOP button.
Please refer to pages 16-17 for Program Profiles.
NOTE: P10 is a Random program. When selected, the unit will adjust the incline to a random
setting every minute.
CUSTOM PROGRAMS (P14, P15)
These are fully customizable programs that will record changes made to Speed and Incline as
you run through the program. These changes made to Speed and Incline will be used in subse-
quent runnings of the program.
1. Press PROGRAM UP button or PROGRAM DOWN button until desired program is selected.
Press ENTER. The TIME window will blink if the program is ready to be programmed, and be
solid if the program has already been programmed. If the program has been programmed
but you wish to re-program values, press the Pause key at this time and the Time window
should begin flashing, indicating that the program is ready to be re-programmed.
2. When the Time window is flashing, use the SPEED + or – arrows or toggles to select your
workout time. Press ENTER.
3. The SPEED window will then blink. Use the SPEED + or – arrows or toggle to select the ini-
tial speed for your workout. Press ENTER.
4. The INCLINE window will then blink. Use the INCLINE + or – arrows or incline toggles to set
your initial workout incline. Press ENTER.
5. To start to program, press the START/STOP button.
6. As the program runs, changes made to Speed and Incline will be recorded every 15 sec-
onds, and these changes will be recalled as they were made in the initial program in subse-
quent operation of the program.
Console Instructions