Filter
Top Products
9. ATTACHING CONNECTING ARMS TO LOCKOUT ROD:
(SINGLE ACTION MODE)
Carefully tap PUSHNUT onto ends of LOCKOUT ROD with
hammer. Lower SLOT in CONNECTING ARM onto LOCKOUT
ROD and slide RETAINER back over LOCKOUT ROD to lock
CONNECTING ARM in SINGLE ACTION MODE.
10. CONNECTING ARM ADJUSTMENT
NOTE:
There are three ADJUSTMENT HOLES in each
CONNECTING ARM. The CONNECTING ARM comes
attached to the END HOLE. The END HOLE puts the
GRIP end of the HANDLEBARS closer to you, which is
better for shorter people. The INSIDE HOLE puts the GRIP
end farther away from you which is better for taller people.
Remove HAIRPIN COTTER and 5/16” WASHER from
PIVOT PIN in HANDLEBAR. Slide desired ADJUST-
MENT HOLE of CONNECTING ARM onto PIVOT PIN of
HANDLEBAR. Place 5/16” WASHER over PIVOT PIN
and insert HAIRPIN COTTER through hole in PIVOT PIN
to lock in place.
12 13