Filter
Top Products
10 11
7. With PIVOT TUBES on rear side of HANDLEBARS and
CONNECTING ARMS to inside, slide RIGHT and LEFT
HANDLEBARS onto AXLE. Slide LARGE WASHER onto
end of AXLE. Carefully tap PUSHNUT onto end of AXLE
with hammer. Connect heart rate wires from CONSOLE
TUBE (B) to heart rate wire in each handlebar (A).
8. ATTACHING CONNECTING ARMS TO PEDALS:
(DUAL ACTION MODE)
Slide RETAINER onto CONNECTING ARM until it has cleared
SLOT in CONNECTING ARM as shown in DETAIL.
Lower SLOT in CONNECTING
ARM down over PEDAL
BUSHING - see Figure A.
Slide RETAINER in direction of
ARROW until CONNECTING
ARM is locked in DUAL
ACTION MODE - see Figure B.
DETAIL
FIGURE A
FIGURE B