Filter
Top Products
PAGE 7
Minor Assembly Required!
ALLIANCE 855/888HR
treadmill is shipped in two pieces: the console upright assembly, and the base
assembly. After opening the box, remove any packing materials from the treadmill. Do not throw away any
packing materials until the unit is working properly. The treadmill box contains a package that includes the
Owners Manual, a RED SAFETY KEY, and a belt adjustment tool. The 888HR will also contain the heart
rate chest strap.
The treadmill will not operate without the Red Safety Key.
The console upright assembly is attached to the base assembly. Place the unit on a clean, level surface near
an electrical outlet (extension cords are not recommended).
See Figure 1
1. Raise the console into an upright position. Loosely install both 3/4” buttonhead screws on each side of
the upright. Install and tighten each 3 1/2” x 5/16” bolt (2) with washers from the bottom of the base
frame through the upright lock (diag. 1).
2. Now tighten the buttonhead screws securely from step 1.
3. Install motor hood cover using 5/8” phillips head screws (8 screws).
Be sure the treadmill is level to the floor. The rear feet can be adjusted to level the treadmill.
Assembly is now complete!
Assembly Instructions
Figure 1