Filter
Top Products
PAGE 7
Assembly Instructions
Figure 1
Figure 2
KEYS
treadmills are shipped in three pieces to make assembly easy. After opening the box,
remove any packing materials from the treadmill. You should find a rear endcap (large
plastic piece that fits over the rear roller area), and owner’s manual packet with bolts and
screws for assembly. Do not throw away any packing materials until the unit is working
properly. Place the base on a clean, level surface. Make sure the electrical cord will easily
reach an electrical outlet.
Figure 1 – Assembly for main uprights
1) Have a second person raise the console to the upright position and hold.
2) Insert 3/4” Button Head Bolt into upright bracket and tighten loosely. Repeat for
opposite side.
3) Insert the TUBE SPACER inside the upright frame and line up with the bottom
hole. Hold tube spacer while inserting the 1 1/2” Button Head Bolt and lightly
tighten. Repeat for opposite side.
4) After completing opposite side, tighten all four assembled bolts and the two other
button head bolts that were present before starting. Assembly is now complete.
5) Be sure to attach the RED SAFETY KEY before turning the power on.
Figure 2 – Assembly for rear end cap
To attach the rear end cap:
1) Place plastic rear end cap over exposed rear roller area.
2) Align holes in plastic end cap with pre-drilled holes in frame.
3) Loosely tighten each screw until all four screws are lined up.
4) Tighten all four screws snugly.
CAUTION:
DO NOT OPERATE TREADMILL WITHOUT SECURING REAR
ROLLER HOUSING!!!
Be sure the treadmill is level to the floor. The rear feet can be adjusted to level the treadmill.
Assembly is now complete!