Kettler TX3 Treadmill User Manual


 
Owner’s Manual
21
and other electrical appliances form an electro-magnetic field around them, which may also
cause problems in heart rate measurement.
PAUSE FUNCTION:
When STOP button is pressed during workout, program is suspended. Message center will
flash “WORKOUT PAUSED”. After the running belt has come to a complete stop, dot matrix
display window will count down from 3:00. During pause mode, only START and STOP buttons
will function.
If START is pressed within three minutes during the pause mode, treadmill will bring the running
belt movement back to the speed at which the treadmill was paused. Workout values will
resume counting and continue where it was left off.
If STOP is pressed during the pause mode, program will end. After three minutes if no button is
pressed, treadmill will automatically end the workout program.
END OF WORKOUT STATS:
When you have completed your workout or if you have ended your workout, the display will
report your workout stats. After the running belt has come to a complete stop, the message
center will display total time, total distance, total calories and average speed twice. Then the
display will go to idle mode, ready for the next user workout setup. If you wish to skip the
workout stats report, simply press the STOP button, which will skip display to the idle mode.
UNIT CONVERSION:
To change from metric to English or English to metric, you must be in the idle mode, where the
dot matrix window displays a flashing heart. Follow the steps below to make the unit
conversion.
1. Simultaneously press both the STOP and SLOW buttons together.
2. The message center will show Km to Mi or Mi to Km.
3. Simply press START to confirm.
Notice that the LED light next to the distance display window on the upper right corner will have
changed the measurement unit accordingly.
PRESET PROGRAMS:
QUICK START:
Once the power switch is turned on, and the safety key is secured in place, simply press the
QUICK START button. Treadmill will activate at 1.0 Km/H. You may increase or decrease
QUICK START
Once the power is on
and the safety tether
key is secured in
place, simply press
the START button,