Filter
Top Products
4
Assembly Instructions
USA
■ For models with pneumatic tires: Due to the nature of materials used in pneumatic tires, it is
not recommended for the product to be left in any one place for too long where solvents or
other chemicals, i.e. oil, may lie. This may result in a chemical reaction, which could cause the
tires to mark the surface such as a vinyl flooring. If in doubt put something underneath the
wheels to cover the floor. Ensure that air pressure in the tires is correct (35 PSI); if air pressure
is too low this increases wear, and makes riding the bike more difficult!
■ Lubricate the bearing sleeves of the wheels and the handlebars with a few drops of oil every
two or three months.
Assembly of the toy vehicle
■ The bike must be assembled carefully by an adult person. Study the assembly instructions
care-fully before beginning work. Assemble the bike in the exact sequence shown by the
letters in the di-agrams. This is essential for the safe function and use of the bike.
■ Please note that there is always a danger of injury when working with tools or doing manual
work. Therefore please be careful when assembling this product.
■ Ensure that your working area is free of possible sources of danger, for example don’t leave
any tools lying around. Always dispose packaging material in such a way that it may not cause
any danger. There is always a risk of suffocation if children play with plastic bags!
■ Bolt all the parts together loosely at first, and check that they have been assembled correctly.
Tighten the locknuts by hand until resistance is felt, then use wrench to finally tighten nuts
completely against resistance (locking device). Then check that all screw connections have
been tightened firmly. Attention: once locknuts have been unscrewed they no longer
function correctly (the locking device is destroyed), and must be replaced.
■ When assembling plastic grips: The grips can be pushed onto the handlebars more
easily if they are first soaked in warm water.
■ For technical reasons, we reserve the right to carry out preliminary assembly work (e.g.
addition of tubing plugs).
List of spare parts
When ordering spare parts, always state the full article number, spare-part number, the quanti-
ty required.
Example order: Model # KT902-182 / Item no. 1/ 1 piece
Please keep original packaging of this article, so that it may be used for transport at a later
date, if necessary. Goods may only be returned after prior arrangement and in (internal)
packaging, which is safe for transportation, in the original box if possible.
It is important to provide a detailed defect description / damage report! Important: spare part
prices do not include fastening material; if fastening material (bolts, nuts, washers etc.) is
required, this should be clearly stated on the order by adding the words “with fastening
material”.
Waste Disposal
KETTLER® products are recyclable. At the end of its useful life please dispose of this article
correctly and safely (local refuse sites).