Filter
Top Products
7
Assembly
WASHER 9*22*2
ALLEN BOLT
M8*15
Pop Pin
Pop Pin
Step 2
While standing on the treadmill, hold onto the center cross bar located
on the console. Carefully lift up and backwards, lifting the uprights into
place.
Do so until you hear the pop pin click. This clicking sound signies that
the left upright is locked into place. This is done to prevent any injury
while proceeding to the following steps.
Align the holes on the treadmill to the holes on the uprights. Secure the
uprights by using two washers 9*22*2 and two allen bolts M8*15 on
each side. Note: Make sure the left upright is all the way back before
installing hardware. Do not overtighten bolts.
WARNING!
The uprights are only being held in place by two pop pins. To prevent personal injury or damage
to the unit, do not lean on the uprights or use excessive force when assembling.