Filter
Top Products
19
Trouble Shooting Guide
Symptom Possible Cause Solution
DC adapter is not plugged into
wall outlet?
Plug DC adapter into wall outlet
DC adapter cord is not
plugged into CDT?
Plug DC adapter cord into CDT power socket
Console cable is not
connected?
Verify that console cable is connected properly
Console has no power
The computer is faulty? Call the Ironman Fitness service number
Check that the sensor magnet is correctly fitted and
passes in front of the sensor
Check that the gap between sensor and the magnet
is 3mm or less
Check that all the computer plugs and sockets are
correctly and firmly connected
Computer isn't receiving a
signal from the sensor?
Check that the computer wires are not damaged
The sensor is faulty? If all above checks are okay, then replace sensor
Strides/Min or Speed
shows 0
The computer is faulty? Call the Ironman Fitness service number
Check that the pulse plugs are firmly inserted into
the sockets
Check to make sure that the batteries in the chest
strap are installed correctly
Replace the chest strap batteries
Check to see if the receiver is properly installed
Check to see if the chest strap is being properly
worn by user - if skin is extremely dry, then
moisten contact points on chest with water and try
again
No HR signal or incorrect
HR signal
Computer is receiving a faint
or intermittent pulse signal
If problem still exists then call the Ironman Fitness
service number
Noise from motor
Symptoms include an
unusually loud noise coming
from the motor, which means
the gears are not meshing
correctly
Try reversing the resistance and try again. If this
fails, then replace the motor.
CLEANING/MAINTENANCE -
Your CDT Elliptical has been manufactured to withstand many hours of use with minimal
maintenance. It may occasionally require silicone to be sprayed on the moving parts (available
at most stores).
Periodically wipe down your machine with mild, soapy water or a diluted general purpose
household cleaner. Machine should be wiped down to remove sweat after each use.