Filter
Top Products
4
2. If there is no illumination LED installed, please follow the procedures bellow to install it.
Release four (4) screws from the SmartEQ face plate, as shown in Figure 5.
Figure 5. Remove face plate screws
Figure 6. Disconnect cables
3. Carefully pull the face plate open. Disconnect the RA and DEC motor drive cables first. Then
disconnect two battery holders from the main board.
4. Lay the face plate with main control board on a table. Align the illumination LED to the top edge
of the board, make sure plus (+) and minus (-) electrodes of the LED are aligned to the + and –
signs on the board, as shown in Figure 7.
Figure 7. Align LED to the main board
Motor cables
Battery cables