Filter
Top Products
SECTION 2—OPERATION
Part No 1148138 13 MA80 Series
Connecting the Power Cord
ƽ WARNING
DO NOT alter plug to fit a non-conforming outlet. Instead, have an electrician
install a properly grounded outlet. Failure to use the correct plug and outlet can
result in a potential safety hazard.
CAUTION
Ensure that the power cord of the control unit is not pinched, or has any objects
placed on it, and also ensure it is not located where it can be stepped on or tripped
over.
NOTE: For this procedure, refer to FIGURE 2.4.
1. Examine the hospital grade power cord supplied with the control unit.
2. Perform one of the following:
• If the plug is damaged - Call your supplier for a replacement hospital grade cord.
• If the plug is not damaged - Plug the end of the supplied hospital grade power cord
into the power outlet on the side of the control unit.
3. Plug the other end of the plug into a properly grounded outlet on the wall.
NOTE: Once the unit is plugged in, an AMBER LED on the control unit is lit indicating that the
system is in STAND BY mode.
FIGURE 2.4 Connecting the Power Cord
Power Outlet
Control Unit