Filter
Top Products
3
Part No. 1078996 Rev. B INVACARE 8000 PRESSURE MATTRESS
INSTALLING
1. Position therapy pad over mattress.
2. Insert one (1) of the ten (10) straps into
open latch as shown in FIGURE 3.
3. Pull strap until therapy pad fits tight
around mattress.
4. Push down on latch to secure.
5. Repeat STEPS 2 - 4 for remaining
nine (9) straps.
6. Secure mattress base to the bed frame.
Refer to SECURING MATTRESS
BASE TO BED FRAME in this
instruction sheet.
REMOVING
1. Remove patient from bed.
2. Pull up on one (1) of the ten (10)
latches that secure the therapy pad
to the mattress.
3. Remove strap from latch.
FIGURE 2- INFLATING THE MATTRESS
Power
Unit
Power
Switch
Knob
+MAX
Setting
Cushion
Fittings
CPR Plugs
Mattress Air Hose
Quick Disconnect
Power Unit Air
Hose Quick
Disconnect
Power
Unit
-MIN
Setting
Transport Mat
Cushion
INSTALLING/REMOVING THERAPY PAD (FIGURE 3)
FIGURE 3 - INSTALLING/REMOVING
THERAPY PAD
Latch
Strap
4. Repeat STEPS 2 - 3 for remaining nine (9) latches.
5. Remove therapy pad from mattress.