Filter
Top Products
STEP 3 (See Diagram 3)
A.) Attach the Leg Developer (#9) to the open bracket on the Front Stabilizer (#5). Secure it
with one M10 x 2 ¾” Hex Bolt (#38), Ø ¾” Washer (#44), and M10 Aircraft Nut (#47). Do
not over tighten the Nut and Bolt. Make sure the Leg Developer is able to swivel.
B.) Insert two Foam Tubes (#10) halfway through the holes on the Leg Developer. Push four
Foam Rolls (#35) onto the Tubes from both sides.
C.) Attach a Spring Clip (#36) onto the weight post on the Leg Developer.
DIAGRAM 3