Filter
Top Products
8
STEP 5 (See Diagram 5)
A.) Attach the ball end of the Cable (#33) to the Pulley (#30). Place the Pulley in the open
slot on the Upper Lat Bar Frame (#52). Secure it with one M10 x 2” Hex Bolt (#40), two
Pulley Bushings (#29), and one M10 Aircraft Nut (#47).
B.) Slide the Weight Holder (#11) onto the Lat Bar Frame.
C.) Insert the Lower Lat Bar Frame (#12) into the Upper Lat Bar Frame. Secure them
together with four M8 x 5/8” Hex Bolts (#41) and four Ø 5/8” Washers (#45).
D.) Connect the Lat Bar (#13) to the Cable with a Hook (#32). Place the Lat Bar Frame onto
the storage post behind the Left Upright Beam. When using the Lat Pull Down, insert the
Lat Bar Frame into the opening on the Front Stabilizer and use the Lock Knob (#37) to
hold it in position.
E.) Connect the Cable to the Weight Holder (#11) with a Hook (#32).